• ◇ 個人搬家服務、家具拆裝、單件運輸
  • ◇ 單位搬場工業機器設備搬場、貨物配
  • ◇ 商務樓、企事業單位搬場。 配套服務
  • ◇ 拆裝家具-備小五金
  • ◇ 空調移機、加氟,加管
  • ◇ 搬場前服務-出售紙箱,有償提供周
  • ◇ 搬場后服務-清理場地、處理廢物
  • ◇ 搬場單派工人-室內搬移、疑難搬移
  • ◇ 貴賓搬場-搬前帶料打包,搬后擺放
  • ◇ 個人搬家服務、家具拆裝、單件運輸
  • ◇ 單位搬場工業機器設備搬場、貨物配
  • ◇ 商務樓、企事業單位搬場。 配套服務
  • ◇ 拆裝家具-備小五金
搬家公司:保定捷達搬家公司
復興路店:13931202615
七一路店:0312-2063366
三豐路店:13930276599
地址:復興東路188號
網址:www.cwbvvm.live
當前位置公司新聞 >> 冰箱搬家過程中注意事項
冰箱搬家過程中注意事項
[來源:http://www.cwbvvm.live] [作者:aowl] [日期:18-03-14] [瀏覽次數:]
1、冰箱應安放在通風良好的地方,如果冰箱周圍堆滿雜物,或者靠墻太近,不利于散熱會影響制冷效果。電冰箱頂面應留有至少30cm高度的空間,背面和兩側面應留有至少10cm的空間,以利散熱。 2、冰箱應安放在平坦堅實的地面上,使冰箱保持水平。這可使壓縮機平穩工作,減少震動和噪音。 3、冰箱不應安放在溫度過低的地方。溫度過低,壓縮機啟動困難,使冰箱冷凍室制冷差。 4、冰箱搬運時箱體最大傾斜角不能超過45度,更不能倒置或橫放,否則會使壓縮機中的冷凍油流入制冷管路,影響制冷,而且易造成壓縮機脫簧。 5、運輸過程中,要防止磕碰和劇烈震動,防止雨淋水浸。 6、冰箱應安放在遠離熱源,不受陽光直射的地方,因工作時需要與外界進行熱交換,通過冷凝器向外界散熱,外界環境溫度越高,散熱越慢,會使冰箱工作時間長,增大耗電量,制冷效果差。 7、冰箱應安放在濕度小的地方,由于冰箱外殼,冷凝器和壓縮機等均是金屬材料,如果空氣濕度太大,會使這些部件生銹,縮短電冰箱的使用壽命。同時潮濕過熱環境,會造成冰箱表面凝露,影響電器性能。 8、冰箱頂部不要放置重物,以防因門的開關使冰箱頂部的物體跌落,造成家人受傷。特別注意,經過搬運的冰箱安放好后,應靜置2個小時以上再通電使用。 1, the refrigerator should be placed in a well ventilated place, if the refrigerator is filled with sundries, or the wall is too close to the wall, it will not affect the cooling effect. The top of the refrigerator should have a space of at least 30cm height, and at least 10cm space should be left on the back and two sides to benefit the heat dissipation. 2, the refrigerator should be placed on a flat and solid ground to keep the refrigerator level. This can make the compressor work smoothly, reduce vibration and noise. 3, the refrigerator should not be placed in a place where the temperature is too low. When the temperature is too low, the starting of the compressor is difficult, so that the refrigerating room of the refrigerator is poor. 4, the refrigerator box when handling the maximum inclination angle of not more than 45 degrees, not upside down or horizontally, otherwise it will make the refrigerant oil in the compressor flows into the cooling pipe, cooling effect, and easy to cause the compressor off spring. 5, in the transport process, to prevent the bump and vibration, prevent rain water. 6 should be placed in the refrigerator, away from heat, without direct sunlight, because of work need to carry out heat exchange with the outside world, radiating to the outside through the condenser, the ambient temperature is high, the heat will make the refrigerator more slow, long working time, increased power consumption, poor cooling. 7, the fridge should be placed in a small humidity area, because the refrigerator shell, condenser and compressor are all metal materials. If the air humidity is too large, these parts will rust and shorten the service life of fridge. At the same time, the humidity and overheating environment will cause the surface condensation of the refrigerator and affect the electrical performance. 8, the top of the refrigerator do not place heavy objects, in order to prevent the switch from the door to the top of the refrigerator object fall, causing family injury. Special attention, after the handling of the refrigerator to be placed well, should be quiet for more than 2 hours to use the electricity.
李逵劈鱼9900炮 第二十四章 卖新样品喜赚钱 模拟炒股游戏 浙江飞鱼 山西新11选5在线开奖 江苏快三计划 中国南车股票分析 七星彩2072期超长规律 开心棋牌有挂吗 幸运赛车开奖结果官网 吉林十一选五最大遗漏 极速十一选五豪华版 日韩联赛投注技巧 新疆时时彩开奖直播现场 股票行情怎么看 mba蓝球即时比分 舟山飞鱼开奖结果